Semnox Solutions Private Limited SPRW001 사용자 설명서
PARAFAIT HARDWARE MANUAL
2011
S E M N O X S O L U T I O N S P V T L T D .
Page 6
Application Details:
1. Click on the wi-fi configuration application to launch the
software.
a. As the software loads, a status message will be displayed to the
user on the connection status (whether the user is connected to
the adhoc network).
the adhoc network).
b. The IP address has been set to 169.254.1.1. Click the connect
button.
c. The application communicates with the device and if the
communication is successful, it will take the device to the
command mode and the user will be able to view the parameters
which have already been set in the reader. Corresponding
messages will be displayed to the user (on the connection status,
parameter retrieval status etc.).The MAC address of the device
too will be displayed to the user.
command mode and the user will be able to view the parameters
which have already been set in the reader. Corresponding
messages will be displayed to the user (on the connection status,
parameter retrieval status etc.).The MAC address of the device
too will be displayed to the user.
d. For the parameters retrieved, the user has the option to modify
the parameters.
e. The user has to enter the parameter in the respective text box
and click on the apply button to set the parameter. In order to
save the changes, the user has to click the save button so that the
changes made by him will be stored in the device permanently.
The status messages will be shown to the user after he clicks the
save button thereby confirming whether the changes have been
saved successfully.
save the changes, the user has to click the save button so that the
changes made by him will be stored in the device permanently.
The status messages will be shown to the user after he clicks the
save button thereby confirming whether the changes have been
saved successfully.
f. Once the configuration is completed we need to POWER ON the
reader.
Setting the device to the ADHOC mode:
1. When the reader loads, hold the DOWN button pressed. Then press
the UP button to enter the ADHOC mode. Press the UP button again
to enter the ADHOC setup.
to enter the ADHOC setup.
2. Once the wifi device enters the ADHOC setup, the following
configuration settings will be applied to it.