Elster Solutions LLC VRT02 사용자 설명서
VRT
R
EMOTE
G
AS
-
METER
T
RANSPONDER
I
NSTALLATION
CHAPTER
6
Page 32
VRT Gas Transponder ― User Guide
AMCO Automated Systems • P/N 52870T010 Rev 1 May 2003
2. Connect brackets A and B using the 2 hex-head slide screws.
• The screw heads should be on the outside of the slot on
bracket A, with their threads started in bracket B holes.
• Slightly finger-tighten the screws so that the bracket width
can still be adjusted.
• The hex screws should be on top—regardless which
mounting position you use—when the bracket assembly is
connected to the meter.
connected to the meter.
3. Remove the two slotted screws already attached to the meter in
the selected mounting location (front or back).
4. Position the transponder brackets in the mounting location and
adjust the bracket mounting holes to the width of the meter
holes.
holes.
Align bracket
mounting
holes with the
mounting
screws
already
installed in
the meter.
mounting
holes with the
mounting
screws
already
installed in
the meter.
Remove
slotted
mounting
screws from
meter
Shown: RIGHT-HAND mounting, meter REAR
B
A
A
Transponder
TOP