Visonic Inc. PWRMCOMPLETE 사용자 설명서

USER SETTINGS

D-300886

Recalling the Last Bypass Scheme

Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the
display will read:

SET BYPASS

Click

twice to change the display into:

RECALL BYPASS

At this point proceed as follows:

ACTION RESULTANT

DISPLAY

OK> TO RECALL

RECALL BYPASS

You may now select any other item on the USER
SETTINGS menu or quit programming by clicking

. When <OK> TO EXIT is displayed - click

Programming 4 Telephone Numbers

Here you determine the 1

, 2

, 3

and 4

telephone

numbers to which the system will report event
messages that were defined by the system installer.
You can ask the installer to set part or all the four
telephone numbers.

Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click

button repeatedly (if necessary) until

the display will read:

SET PHONE NUMBER

You are allowed to program the 4 numbers as follows:

PRESS RESULTANT

DISPLAY

1st private tel#

XXXXXXXXX

[Enter Tel. No.]

XXXXXXXXX

1st private tel#

2nd private tel#

Continue the same way up to telephone number 4.

You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking

until <OK> TO EXIT is displayed and

then clicking

Setting the User Codes

A maximum of eight 4-digit codes can be defined out
of a total of (10)

= 10000 user code possibilities.

Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click

until the display reads:

SET USER CODES

User Code 1 replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.

User Codes 2, 3 and 4 can be assigned to additional
users - family members, co-workers etc.

Codes 5 through 8 are assigned to “Latchkey
Users” (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).

CAUTION! Code “0000” is not valid! Do not use it.

Note: The duress code set by the installer (2580 by
default) cannot be selected as a normal user code.
Any attempt to program it will be rejected by the
PowerMaxComplete.

To program the codes, proceed as follows:

PRESS RESULTANT

DISPLAY

user code 1: _ _ _ _

user code1:

0 0 0

user code 1: 685

[4-digit

user code]
e.g. 6854)

user code 1: 6854

user code 2

Continue the same way up to Code 8.

user code 8: 5537

SET USER CODES

You may now select any other item on the USER
SETTINGS menu or quit programming by clicking

. When <OK> TO EXIT is displayed - click