ACCO Brands M01042-V 사용자 설명서
Product Engineering Specification
Document
PES-K33440 Rev
0.8
March 27, 2008
Confidential
Page 9 of 19
• Other ambient noises
o
The prime audio solution (firmware based) for ET will be provided by Primax
o
Echo rejection: >42 dB
o
Convergence in presence of back ground noise: < 1.0 sec
o
Noise Cancellation: 12 dB
o
No Distortion or speech clipping
o
Comfort noise injection for natural sounding conversations
o
Enhanced Non-linear processor for suppression of residual echo
o
Microphone:
• Omni directional microphone to be used
• To be isolated via a rubber “boot” to prevent vibration transmission
• Not to be rigidly mounted to the PCB, should be mounted to the plastics
and attached to the PCB via flying leads
• RF filtering a must to reduce TDMA noise issues
• 6mm diameter microphone to be used
• Microphone SNR to be min 55 dB
• The microphone is to be located on the front face plate for optimum user
orientation.
• Sensitivity greater than -45 dBV at 1KHz
•
Reference Microphone:
•
Kingstate Microphone with flying leads.
•
KECC2244WBL-G9U
3.6 Recharging requirements.
Visor BT handsfree Product will ship along with:
- 2 rectangular NiMH battery packs with contacts (no flying leads)
- USB battery charger
-CLA – USB power adapter
- 2 rectangular NiMH battery packs with contacts (no flying leads)
- USB battery charger
-CLA – USB power adapter
3.7 Battery Pack Specifications
-Must meet 3.3 Power requirements
-Rectangular battery enclosed in plastic (user replaceable)
-Clean look. Shrink wrapped battery packs are not acceptable.
-800mAh
-NiMH Chemistry
-Rectangular battery enclosed in plastic (user replaceable)
-Clean look. Shrink wrapped battery packs are not acceptable.
-800mAh
-NiMH Chemistry
3.8 USB Battery Charger:
-Includes NiMH charging circuit for Battery pack.
-Includes cavity to accept NiMH Battery Pack
-Includes cavity to accept NiMH Battery Pack
3.9 CLA USB Power adapter Specifications:
-
Plugs into 12V power socket of car
-Fused 2AMPS SMT Quick burn
-Includes USB Power circuit which meets the following iPhone 5V power requirements
(Kensington will provide proven reference design to meet these requirements:
-Includes USB Power circuit which meets the following iPhone 5V power requirements
(Kensington will provide proven reference design to meet these requirements:
In order to reduce PCB space an SMT type fuse it to be used, rated to 2 Amps.