Fimi Srl 802161 사용자 설명서
12” LCD ProScribe Xper module Atom
23
12. TROUBLESHOOTING
12.1. THE 12” LCD ProScribe Xper module Atom WILL NOT TURN ON...
When power is on, you will see:
On the pad: Power indicator light above the screen on the right will turn green
If power is on, but you still don’t see anything on the screen, wake up the pad by tapping on the screen or by pressing
control buttons located on the right hand side of the screen.
On the pad: Power indicator light above the screen on the right will turn green
If power is on, but you still don’t see anything on the screen, wake up the pad by tapping on the screen or by pressing
control buttons located on the right hand side of the screen.
If pad does not power on, check that;
the AC adapter is plugged into the DC in of the 12” LCD ProScribe Xper module Atom (D-SUB 9 connector), and
make sure that the
Adapter is also plugged into the wall socket.
the AC adapter is plugged into the DC in of the 12” LCD ProScribe Xper module Atom (D-SUB 9 connector), and
make sure that the
Adapter is also plugged into the wall socket.
If the preceding steps do not turn the pad on, try restarting the machine:
As a last resort remove the power cord , wait ten seconds then insert again the power cord, to switch on the
12” LCD ProScribe Xper module Atom or try to push the reset switch button located between the 2 USB ports.
As a last resort remove the power cord , wait ten seconds then insert again the power cord, to switch on the
12” LCD ProScribe Xper module Atom or try to push the reset switch button located between the 2 USB ports.
12.2. MY SYSTEM DOES NOT RUN SMOOTHLY
Poor wireless signal quality or the simultaneous opening of too many applications will cause deterioration in application
performance.
To free up memory, close applications that are not in use.
Check wireless signal quality:
performance.
To free up memory, close applications that are not in use.
Check wireless signal quality:
WLAN LED indicator. When the WLAN LED indicator is blue, a wireless signal is available.
If signal is weak, try moving closer to your Access Point, or try repositioning the antenna of the access point.
If signal is weak, try moving closer to your Access Point, or try repositioning the antenna of the access point.
Network icon. Double tap the Network icon on the bar at the bottom of the screen. Choose the Wireless Information
tab to show the current connection.
tab to show the current connection.
12.3. HOW DO I TURN OFF MY 12” LCD ProScribe Xper module Atom
To end operation, click on the ‘start’ button and then click on the ‘Shut Down’ button to turn off the pad.
12.4. WHEN I USE THE STYLUS PEN...
? System does not respond to taps…
Try tapping the center of an icon, or re-calibrate the touch screen.
Try tapping the center of an icon, or re-calibrate the touch screen.
? The mouse arrow is out of alignment…
The mouse arrow does not point to the center of icon as you intend. It might be due to the viewing angle
or the touch screen may require calibration.
The mouse arrow does not point to the center of icon as you intend. It might be due to the viewing angle
or the touch screen may require calibration.
? Users accustomed to a mouse device use a right click for quick access to command options of an object.
The stylus pen offers a similar command function. Here’s how: See chapter 8.2
The stylus pen offers a similar command function. Here’s how: See chapter 8.2
NOTE:
You might need to practice a couple of time in to operate your screen with taps.