DTC Communications Inc. PD2TX1000S 사용자 설명서
7
OPERATION
Using your Palladium II Transmitter
Follow the instructions given in the Quick Start section on pages 4-5. When power is first
applied to the Palladium, the unit reverts to the indicated channel and RF ON state. The Alarm
LED may be ON, which indicates that there is no active video input.
applied to the Palladium, the unit reverts to the indicated channel and RF ON state. The Alarm
LED may be ON, which indicates that there is no active video input.
Changing your Transmitter Configuration
The Palladium Transmitter can store up to 8 different configurations, which can be selected
with the Channel Control. Each of these configurations are programmed into the transmitter by
the factory at the time of order.
To cycle through your preconfigured channels rotate the knob to the next setting.
with the Channel Control. Each of these configurations are programmed into the transmitter by
the factory at the time of order.
To cycle through your preconfigured channels rotate the knob to the next setting.
NOTE: FCC 90.203 (e) prohibits anyone other than the manufacturer, qualified service
or maintenance personnel from altering the frequency programming of the transmitter.
Please contact the factory for additional information regarding programming
frequencies.
or maintenance personnel from altering the frequency programming of the transmitter.
Please contact the factory for additional information regarding programming
frequencies.