DTC Communications Inc. PDTX5000A 사용자 설명서

Follow the instructions given in the Quick Start section on pages 4-5.
When power is first applied to the Palladium, the unit reverts to the last
used channel and RF is turned ON. One of the green channel LEDs will
turn ON indicating the active channel. The Alarm LED may be ON, which
indicates that there is no active video input.

The Palladium Transmitter can store up to 8 different configurations,
which can be selected on the front panel. Each of these configurations can
be programmed into the Transmitter with the supplied DTC Programming
Software and a Windows PC. Refer to the Programming section on page 10
for more information.

To cycle through your preconfigured channels press the CONFIG button
once to advance to the next setting. By default, the Palladium will turn
OFF the transmitted signal while you are changing channels. This is to
prevent accidental interference. Push the RF button after channel selection
to resume RF transmission of your video image.

To place your Palladium Transmitter in (low current consumption) standby
mode, hold the RF button for one second. The RF LED turns OFF
indicating the TX is now in standby mode. Push RF again to resume
transmitting.

Palladium TX-5000A

Transmitter Control Panel