HeathCo LLC WLTRX5892 사용자 설명서

 

2

5-Year Limited Warranty ........................3

Planning Installation ..............................3
Specifications ........................................3

Tools Required .......................................4
Hardware Included .................................5
Package Contents ..................................5

 

Ƒ Please read and understand this entire manual 

before attempting to assemble, install, or operate 
this light fixture.

 

Ƒ This light fixture requires a 120-Volt AC power 

source.

 

Ƒ Some codes require installation by a qualified 

electrician.

 

Ƒ This light fixture must be properly grounded.

 

Ƒ This light fixture should be installed outdoors to a 

wall or eave.

 

Ƒ The light fixture should be mounted approximately 

8 ft. (2.4 m) above the ground. If the light fixture 
is mounted higher than recommended, aiming the 
sensor down will reduce the coverage area.

 

Ƒ The light fixture/camera requires constant power 

to operate. Whenever the power is turned on to 
the light fixture (either for the first time or after 
a power outage), the light requires a 60-second 
boot-up period before the camera will be fully 
operational.

 

Ƒ Many states regulate the use of security cameras 

and other recording devices. It is the purchaser’s 
sole responsibility to ensure compliance with all 
applicable laws and to provide any legally required 
notices. Check local laws regarding the use of any 
recording devices and cameras prior to installation.

WARNING: Turn the power off at the circuit breaker or 
fuse. Place tape over the circuit breaker switch and verify 
power is off at the light fixture.

WARNING: Risk of fire. Keep the lamp heads at least 
2 in. (51 mm) from combustible materials.

CAUTION: Burn hazard. Allow the light fixture to cool 
before touching.

NOTICE: Do not connect this light fixture to a dimmer switch or 
timer.

 

Ƒ This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.

 

Ƒ This device complies with Industry Canada licence-

exempt RSS standard(s). Operation is subject to the 
following two conditions: (1) this device may not 
cause interference, and (2) this device must accept 
any interference, including interference that may 
cause undesired operation of the device.

 

Ƒ CAN ICES-3 (B)/NMB-3(B)