HeathCo LLC WLTRX5892 사용자 설명서

 

6

NOTE: The light fixture should be mounted approximately 
8 ft. (2.4 m) above the ground. If the light fixture is 
mounted higher than recommended, aiming the sensor 
down will reduce the coverage area.

 

Ƒ Determine the mounting location – wall or eave 

mount.

 

Ƒ Position the lamp heads (A) in the general 

direction of the desired light coverage.

 

Ƒ If needed, rotate the motion sensor (C) so the 

text faces upward.

Wall Mount

Eave Mount

180°

THIS SIDE UP

NOTE:  This fixture comes with a mounting plate (D). It is 
pre-assembled on the light fixture (B) for shipping.

NOTE: The small mounting bolt (EE) is pre-installed in 
the light fixture (B). Do not attempt to remove the small 
mounting bolt (EE).

 

Ƒ Unscrew the small mounting bolt (EE) connecting 

the light fixture (B) to the mounting plate (D) and 
remove the mounting plate (D).

WARNING: Turn the power off at the circuit breaker or 
fuse. Place tape over the circuit breaker switch and verify 
power is off at the light fixture.

NOTE: Six mounting bracket screws of various sizes are 
included. The installation will only require two. Discard the 
unused mounting bracket screws after installation.

 

Ƒ Remove the existing light fixture.

 

Ƒ Install the mounting bracket (FF) with the 

stamped word “FRONT” facing away from the 
junction box. Use the mounting bracket screws 
(BB or CC) that best fit the junction box.

 

Ƒ Firmly pull on the mounting bracket to verify 

it is securely mounted to the junction box. If 
necessary, use the screws that were removed 
from the existing light fixture.

EE

D

B

BB or CC

FF

A

C