Toshiba TEC Corporation GN1050 사용자 설명서

 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses, and 

can radiate radio frequency energy. If not installed and used in accordance with the instructions, 

it may cause harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. 

 

If this equipment does cause harmful interference to radio or television reception, which can be 

determined by tuning the equipment off and on, the user is encouraged to try and correct the 

interference by one or more of the following measures: 

-Reorient or relocate the receiving antenna. 

-Increase the distance between the equipment and the receiver. 

-Connect the equipment to outlet on a circuit different from that to which the receiver is 

connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 

(2) This device must accept any interference received, including interference that may cause 

undesired operation. 

Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment. 

 

Labelling 

Toshiba TEC Wireless LAN Module GN-1050 labelled as below. 

FCC ID: BJI-GN1050 

The proposed FCC ID label format is to be placed on the module. If FCC ID is not visible when 

the module is installed into the system, “Contains FCC ID:BJI-GN1050” shall be placed on the 

outside of final host system. 

 

Caution: Exposure to Radio Frequency Radiation. 

To comply with FCC RF exposure compliance requirements, a separation distance of at 

least 20 cm must be maintained between the antenna of this device and all persons. This 

device must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

GN-1050 Operator’s Manual — PRECAUTIONS                                                                                5A