Salco Industries Inc SST011198 사용자 설명서
COMMUNICATION CERTIFICATION LABORATORY
TEST REPORT: 73-6741
FCC ID: BZD-SST011198
Page 33 of 48
Exhibit 8
I M P O R T A N T! !
This manual should be read and understood in its entirety before attempting to install or program
the system. This manual has been developed by SALCO INDUSTRIES and this manual is
intended for use only by its industrial and commercial trade customers and service personnel.
the system. This manual has been developed by SALCO INDUSTRIES and this manual is
intended for use only by its industrial and commercial trade customers and service personnel.
The information presented in this manual has been carefully checked and is believed to be
accurate; however, no responsibility is assumed for inaccuracies.
accurate; however, no responsibility is assumed for inaccuracies.
SALCO reserves the rights to make changes without further notice to the products specified
herein to improve reliability, function, or design.
herein to improve reliability, function, or design.
SALCO radio controls provide a reliable communications link and fill an important need in
portable or wireless signaling. However, there are some limitations, which must be observed.
portable or wireless signaling. However, there are some limitations, which must be observed.
•
The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As
such, they have limited transmitter power and therefore limited ranges.
•
Receivers may be blocked by radio signals that occur on or near their operating frequencies,
regardless of code settings.
•
A receiver cannot respond to more than one transmitted signal at a time.
•
Infrequently used radio links should be tested regularly to protect against undetected
interference or fault.
•
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale
distributor, dealer, or private installer, and these facts should be communicated to the ultimate
users.
users.
C A U T I O N !
The manufacturer strongly recommends that you test security equipment frequently.
Over a period of time, no electronic products are better than the inspection and
maintenance they receive. Therefore, from the time of installation, it is a good idea to test
the supervised security system at least once a week.
Over a period of time, no electronic products are better than the inspection and
maintenance they receive. Therefore, from the time of installation, it is a good idea to test
the supervised security system at least once a week.