Foxpro Inc 660 사용자 설명서

6-3

Updating the Transmitter Playlist & Category List

Now that you are done programming the Inferno, you are ready to download the new playlist to the

transmitter. You will need to obtain a 3.5mm male-to-male stereo cable for this process.

Disconnect all accessories from the Inferno (i.e. speakers or decoy) and make sure that it is

turned off.

Turn on the transmitter.

Connect the 3.5mm cable from the sound upload jack on the transmitter to the AUX jack on the

Inferno.

The transmitter will display a message, “Turn caller off. Connect remote to AUX jack on call.”

Select “OK” to clear the message.

Power on the Inferno to initiate the transfer. The display on the remote updates as the transfer

progresses. It displays the number of sounds transferred and whether or not a valid category file
has been found. When complete, the screen returns to the normal view.

Unplug the cable from the transmitter and Inferno. Browse through the categories or sound list

to view the changes.

Product Care & Maintenance

In order to help get years of trouble free service with your FOXPRO game call, it is strongly recommended

that you read and understand the following points. Many of these are considered proactive or preventative.

Avoid exposure to all precipitation and moisture. Moisture (perhaps from rain, snow, condensation, or

other) can potentially enter the unit or the battery compartment and cause serious problems. Proper care

should be taken to mitigate the introduction of moisture into the machine and make sure that no moisture

is present during storage. Moisture can quickly lead to corrosion, electrical shorts, and even rust—all of

which can render the unit damaged and out of warranty. This type of damage is preventable! If you are

operating in rainy, wet conditions, it is recommended that you place the unit inside of a large plastic storage

bag or use a water/weatherproof deployment bag to keep water from getting to it. When storing the unit

for prolonged periods, be sure that you keep it in a dry location.

Remove batteries prior to storage or extended periods of inactivity! All batteries, whether alkaline or

rechargeable, should be removed from the game calls, decoys, and transmitters prior to storage or periods

of inactivity. Batteries left inside of electronic devices can leak over time. Damages caused by this can be

severe and potentially destroy the electrical components. To prevent this from happening, simply remove

all batteries from all devices before you put them away. Keep in mind: damage caused by battery leakage is

not covered under warranty.

Troubleshooting

The most common problems are battery related. Before performing anything else, try installing fresh

batteries. When your batteries get low, in either the Inferno or the Inferno transmitter, unexpected

operation can occur. You can experience such things as loss of audio quality, loss of transmitter range, and

other abnormal results.

PROBLEM

SOLUTION

Inferno will Not Turn On

Make sure that you have fresh batteries installed. If using

rechargeable batteries, make sure they are fully charged.

Inspect the battery tray and make sure the springs are not

compressed or corroded as this could lead to poor battery

connectivity.