Tait Limited TBA7B1 사용자 설명서

TB8100 Installation and Operation Manual

© Tait Electronics Ltd March 2004

Take care when handling a PMU or PA which has been operating recently.  
Under extreme operating conditions (+ 60°C [+140°F] ambient air 
temperature) or high duty cycles the external surfaces of the PMU and PA 
can reach temperatures of up to + 80°C (+176°F).

This equipment contains devices which are susceptible to 
damage from static charges. You must handle these devices 
carefully and according to the procedures described in the 
manufacturers’ data books.

We recommend you purchase an antistatic bench kit from a reputable 
manufacturer and install and test it according to the manufacturer’s 
instructions.  

Figure 5.1

 shows a typical antistatic bench set-up.

You can obtain further information on antistatic precautions and the dangers 
of electrostatic discharge (ESD) from standards such as ANSI/ESD 
S20.20-1999 or BS EN 100015-4 1994. 

The TB8100 BSS equipment has been designed to operate safely under a 
wide range of aerial loading conditions.  However, we strongly recommend 
that the transmitter should always be operated with a suitable load to prevent 
damage to the transmitter output power stage.

common point ground 
(building ground or 
mains ground via 1M 
ohm series resistor)

conductive wrist strap

dissipative rubber 
bench mat