Digital Monitoring Products Inc PC0181 사용자 설명서

At the 

STOP option, pressing any select key allows you to exit the programmer 

function of the XTLplus panel. When selected, the panel performs an internal reset 

and exits the programmer. The Stop function causes the following conditions to 

occur:

• All 1100 Series DMP Wireless transmitters are reset to NORMALxx

• The panel’s Status List is CLEARED

During the Stop function, all keypad displays are momentarily disabled for two 

seconds. Afterwards, the programming function is terminated and the keypads 

return to the Status List display.

Pressing COMMAND at the Stop option displays 

SET LOCKOUT CODE. This feature 

allows you to program a special code that will then be required to gain access to 

the panel’s internal Programmer through the keypad.

Changing the Lockout Code 

You can change this code at any time to any combination of numbers from 1 to 5 

digits long (1 to 65535). 

1. Press any select key. The display changes to 

ENTER CODE: -.

2.  Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press 

COMMAND.

3.  Enter the new Lockout Code again. Press COMMAND. The keypad display changes 

to 

CODE CHANGED.

Once you have changed the code, it is important that you write it down and store 

it in a safe place. Lost lockout codes require the panel to be sent back into DMP 

for repair. You may cancel a Lockout Code by entering 00000 at the Set Lockout 

Code command option.

Do not set a Lockout Code higher than 65535.

SET LOCKOUT CODE