Laird Controls North America Inc. R3A 사용자 설명서
Page 2 of 4
09/2003, CATTRON-THEIMEG
™
Radio Frequency (RF) Transceiver.
The RCR 'Gold Box' incorporates the R3HNX Transceiver Board, together with its ‘companion’ RF
Power Amplifier Board.
Power Amplifier Board.
The R3HNX Transceiver Board is a multi channel, UHF-synthesized RF receiver with a Liquid
Crystal Display (LCD). Additionally, it has a built in RF transmitter for ‘POLLING
Crystal Display (LCD). Additionally, it has a built in RF transmitter for ‘POLLING
™
’ data
transmission. The R3HNX receiver section incorporates a microprocessor and uses Digital Signal
Processing (DSP) techniques to selectively recover digital messages using CATTRON-THEIMEG
Processing (DSP) techniques to selectively recover digital messages using CATTRON-THEIMEG
™
protocol. The receiver section also has LED indicators for:
•
Power ON
•
Carrier Detect (RF signal or carrier is present)
•
VCO Lock (receiver locked on freq.)
•
Data (received message data)
•
Q-sync (synchronization pulse)
The RF Power Amplifier Board is a high power RF amplifier that connects between the R3HNX
Transceiver Board and the Antenna Connector. An on-board LED indicator shows when trans mitted
digital RF ‘POLLING
Transceiver Board and the Antenna Connector. An on-board LED indicator shows when trans mitted
digital RF ‘POLLING
™
’ data from the R3HNX transmitter is being amplified and sent to the RCT.
Opening the front door of the RCR enclosure and removing the 'Gold Box' lid will expose the R3HNX
Transceiver Board, together with its ‘companion’ RF Power Amplifier Board. Referring to Figure
1-7 and Table 1-2 below, transceiver and amplifier board LED indicators indicate system status and are
particularly useful when troubleshooting and adjusting the transceiver.
Transceiver Board, together with its ‘companion’ RF Power Amplifier Board. Referring to Figure
1-7 and Table 1-2 below, transceiver and amplifier board LED indicators indicate system status and are
particularly useful when troubleshooting and adjusting the transceiver.
Information to the User regarding FCC Compliance:
Changes or modifications not expressly approved by the manufacture could void the user's authority to
operate the equipment.
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions; (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
conditions; (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF Exposure Information:
Installation of this RF device requires the antenna to be mounted in a manner that ensures a 36cm
minimum separation distance from the end user(s).
minimum separation distance from the end user(s).