NBS Payment Solutions Inc. NOIRE510C 사용자 설명서
510C
Hand-Over Terminal
USER GUIDE
NBS Payment Solutions Inc.
Corporate Headquarters - Canada
703 Evans Avenue, Suite 400
Toronto, Ontario, M9C 5E9
Canada
Tel: +1 416 621-7410
Fax: +1 416 621-2450
Fax: +1 416 621-2450
510C User Guide
UNPACKING THE
510C
Carefully preserve the packaging of the terminal. It must
be re-used whenever the terminal is shipped.
Packaging contains:
be re-used whenever the terminal is shipped.
Packaging contains:
• The terminal itself, equipped with its paper roll.
• Communications Cable. The
510C may be
ordered with a choice of communications cables:
-
020D - Dial-up modem
-
020E – Single port Ethernet
-
020S – Two port Ethernet switch
• Detachable power supply unit. (The power supply unit
delivered with your terminal is specially designed for
it. Do not use any other power supply.) The use of a
power supply having apparently similar
voltage/current characteristics may, in spite of this,
damage your terminal.
it. Do not use any other power supply.) The use of a
power supply having apparently similar
voltage/current characteristics may, in spite of this,
damage your terminal.
• Installation Guide.
SAFETY INSTRUCTIONS
To power down the
510C:
•
Disconnect the power supply block from the
electric power supply network.
electric power supply network.
Electrical Power Supply Network
Provide an A.C receptacle that meets the following
recommendations:
• Connector is installed near the equipment and is
easily accessible
CONNECTING THE POWER SUPPLY
Select an electrical socket that complies with the general
safety instructions as outlined in “Safety Instructions.”
Connecting the Power Supply to the
Communications Cable
safety instructions as outlined in “Safety Instructions.”
Connecting the Power Supply to the
Communications Cable
•
Insert the small
connecter on the
power supply cable
into the socket in the
communications cable.
connecter on the
power supply cable
into the socket in the
communications cable.
•
Rotate the
connector 90
to the right to
lock the cable
in place.
connector 90
to the right to
lock the cable
in place.