SHENZHEN AOB ELECTRONICS CO. LTD ES52040BT 사용자 설명서

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 

(1) this device may not causeharmful interference, and 

(2) this device must accept any interference received, including interference 

that may cause undesired operation. 

Changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment. 

 

NOTE: This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following 

measures: 

-- Reorient or relocate the receiving antenna. 

-- Increase the separation between the equipment and receiver. 

-- Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected. 

-- Consult the dealer or an experienced radio/TV technician for help.

 
 FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
 uncontrolled environment. In order to avoid the possibility of exceeding the
 FCC radio frequency exposure limits, Human proximity to the antenna shall
 not be less than 20cm (8 inches) during normal operation.