Nikko Co Ltd RN6201H 사용자 설명서

다운로드
페이지 7
English
2
English
RDC-060002A  ( FCC )
3 language
Do not charge Battery Pack immediately after use.Wait until it is cooled before charging.
Avoid short circuits. Short circuits will cause overheating, burning of the cords and other 
damages to the Battery Pack and Charger.
The Ni-CD Battery Charger should be used for charging one Battery Pack . Do not use the 
charger for charging other types of batteries and battery packs.
Do not use the Charger as a direct current outlet for other electrical appliances or machines.
Make sure that the Battery Pack and Charger are kept out of the hands of infants and small 
children while charging.
Do not charge near fires, where the temperature is extremely high, or where it is wet or damp.
The charger will become slightly heated while charging. Allow sufficient free space around the 
Charger.
If the power of the battery pack is weak in spite of proper charging. The batteries may be worn out 
from repeated use. Replace it with a new Ni-CD battery pack.
Dispose of use Ni-CD battery packs correctly.
Disconnect the supply before making or breaking connections to the battery.
WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
Please use this battery charger only for the charger of the   rechargeable battery pack.
The NI-CD battery pack should be recharged under the supervision of an adult.   
RECHARGING
CAUTION
Pass the antenna wire through the antenna tube, then insert the tube into the antenna tube holder.
If the antenna tube cannot be successfully inserted into the antenna tube holder, try holding the 
root of the antenna wire with fingers of one hand and extending the wire with fingers of the other 
hand.
* Note: Be careful not to pull antenna wire too strong.
1. HOW TO ATTACH ANTENNA TUBE
Antenna wire
Antenna tube
Antenna tube
 holder
BEFORE YOU START
"WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT."
*   The newly purchased Ni-Cd pack is not charged.
     Recharge before operate.
1. Join the connector of the charger to the
    connector of the Ni-Cd battery pack.
2. Plug the charger into an electrical outlet.
3. Recharge for about 4-5 hours.
4. When the recharging is over, plug out the
charger from the electrical outlet and detach
the connectors.
Charger
Charger
Household 
outlet
Household 
outlet
Ni-Cd battery pack 
Ni-Cd battery pack 
OR