Sennheiser Electronic Corp RR2000 사용자 설명서
Putting the RS 2000 into operation
14 |
RS 2000
Charging the stethoset receiver’s rechargeable
battery
battery
A complete charging cycle takes about 3 hours. Before using the
receiver for the first time, charge its rechargeable battery for a com-
plete charging cycle without interruption.
receiver for the first time, charge its rechargeable battery for a com-
plete charging cycle without interruption.
When the rechargeable battery is almost empty, the
Receiver status
LED lights up red. The stethoset receiver switches off after a few
minutes.
minutes.
왘
Place the stethoset receiver into the transmitter’s charging com-
partment so that the volume buttons face upwards. The ste-
thoset receiver is magnetically oriented to the correct position.
The stethoset receiver automatically switches off and the
partment so that the volume buttons face upwards. The ste-
thoset receiver is magnetically oriented to the correct position.
The stethoset receiver automatically switches off and the
Bat-
tery
LED
on the transmitter lights up red. When the recharge-
able battery is fully charged, the
Battery
LED
goes off.
If the
Battery
LED
on the transmitter flashes red, a charging
error/battery error has occurred. In this case, remove the stethoset
receiver from the transmitter’s charging compartment. More infor-
mation on the rechargeable battery can be found on page 20.
receiver from the transmitter’s charging compartment. More infor-
mation on the rechargeable battery can be found on page 20.
3 h
100
%
Always store the stethoset receiver in the transmitter’s
charging compartment to ensure that it is fully charged when
needed. The intelligent battery charging technology prevents
overcharging.
charging compartment to ensure that it is fully charged when
needed. The intelligent battery charging technology prevents
overcharging.
3 h
100
%
Off