Keystone Heddolf International O220390 사용자 설명서
INSTRUCTIONS FOR Radio Control Operator
Single entry transmitter, Mini Transmitter,
Read the following instructions thoroughly before using the remote.
This transmitter must be adjusted so that the coding switches match the coding on your present operating
transmitters or receiver
FCC Regulations: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation
Programming Remote Controller to the Opener
1. Remove the Transmitter Cover
Remove the access cover from the front of the transmitter by sliding the
cover away from the top of the transmitter (Figure A). This will expose
the battery and the dip switches. The code can now be changed using a
small screwdriver.
cover away from the top of the transmitter (Figure A). This will expose
the battery and the dip switches. The code can now be changed using a
small screwdriver.
2. Setting the codes
You may set your transmitter to any code you desire, but be sure the code
you set matches both your transmitter and receiver.
There are nine (9) dip switches, each of which can be placed in three
different positions (+,0,-). DO NOT set all switches in the same position,
such as all +, all 0, all -, (Figure B). WARNING: No other adjustments
should be made inside the transmitter.
you set matches both your transmitter and receiver.
There are nine (9) dip switches, each of which can be placed in three
different positions (+,0,-). DO NOT set all switches in the same position,
such as all +, all 0, all -, (Figure B). WARNING: No other adjustments
should be made inside the transmitter.
Warning
To avoid possible serious injury or death from a garage door or moving gate:
-Keep all remote controls out of children’s reach at all times. Never allow children near batteries!
-Only activate door or gate when it is in clear view and is in proper working condition.
-Always completely monitor garage door and gate opener until completely opened or closed.
-Never allow anyone to cross area of opening and closing of moving garage door or gate.
-Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Copyright@ Keystone/Heddolf Remotes 2015
ME-70-0001
-Keep all remote controls out of children’s reach at all times. Never allow children near batteries!
-Only activate door or gate when it is in clear view and is in proper working condition.
-Always completely monitor garage door and gate opener until completely opened or closed.
-Never allow anyone to cross area of opening and closing of moving garage door or gate.
-Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Copyright@ Keystone/Heddolf Remotes 2015
ME-70-0001
Slider the cover for battery
replacement
Battery Type: 23A
replacement
Battery Type: 23A
Figure A
Figure B