Uniden America Corporation UB315 사용자 설명서

84

• Turn the scanner Off before disconnecting the power.

• Always write down the programmed frequencies in the

event of memory loss.

• If memory is lost, simply reprogram each channel. 

The display shows 000.0000 in all channels when there has
been a memory loss.

• Always press each button firmly until you hear the entry

tone for that key entry, unless you have turned 

OFF

the 

KEY BEEP

in the menu system.

• Do not use the scanner in high-moisture environments such

as the kitchen or bathroom.

• Avoid placing the unit in direct sunlight or near heating 

elements or vents.

• If the scanner receives strong interference or electrical

noise, move it or its antenna away from the source of the
noise. If possible, a higher elevation, may provide better
reception. Also try changing the height or angle of the
antenna.

• Disconnect the power to the unit before cleaning.

• Clean the outside of the scanner with a mild detergent. 

To prevent scratches, do not use abrasive cleaners or sol-
vents. Be careful not to rub the LCD window.

• Do not use excessive amounts of water.

• Do not attempt any repair. The scanner contains no user

serviceable parts. Contact the Uniden Customer Service
Center or take it to a qualified repair technician.

• All radios can receive birdies (undesired signals). If your

scanner stops during Scan mode and no sound is heard, it
may be receiving a birdie. Birdies are internally generated
signals inherent in the electronics of the receiver.

Press L/O to lockout the channel, and then press RSM
to resume scanning.

BC250D  9/20/2 2:52 PM  Page 84