Mattel Toys A Division of Mattel Inc 47999-02A2T 사용자 설명서

© 2002 Mattel, Inc., El Segundo, CA 90245 U.S.A. All Rights Reserved. Mattel East Asia Ltd., 
World Finance Centre, Harbour City, Tsimshatsui, HK, China.

Retain this address for future reference:
Mattel U.K., Ltd., Vanwall Business Park, Maidenhead SL6 4UB.
Help line 01628500303

•   Non-rechargeable batteries are not to be recharged.
•   Rechargeable batteries are to be removed from the 
     toy before being charged (If designed to be removable).
•   Rechargeable batteries are only to be charged under
     adult supervision (If designed to be moveable). 
•   Do not mix alkaline, standard (carbon-zinc), or 
     rechargeable (nickel-cadmium) batteries.
•   Do not mix old and new batteries.

•   Only batteries of the same or equivalent type as
     recommended are to be used.
•   Batteries are to be inserted with the correct polarity.
•   Exhausted batteries are to be removed from the toy.
•   The supply terminals are not to be short-circuited.
•   Dispose of batteries safely. Do not dispose of in fire as 
     batteries may explode or leak.
•   Products with non-replaceable batteries are not to be disposed
     of in a fire as the batteries inside may explode or leak.

To prevent entanglement, 
keep hair away from wheels.

Please keep these instructions for future reference,  as they contain important information.

 Insert 3 "AA" (LR6) alkaline batteries

     (not included), as indicated inside the
     battery compartent.

Remove the labels from the sticker sheet and place
anywhere on the skateboard, helmet and/or controller

Pull ends of strips to release hair. Remove any remaining
thread from hair.

Replace and screw the battery door

     after installing the batteries

Unscrew and remove the battery door.

 Insert one "9V" alkaline battery (not included), as indicated inside the battery

     compartent.

Close the battery door.

Surface washable

Slide open the battery door.

Press the power ON/OFF button on the 

     top of the skateboard to turn the unit 
     on and off.

To turn the product off, pick up by the back

of the skateboard or lift the doll by the head and
press the On/Off button.

The skateboard spins clockwise continuously

     when the Power button is pressed ON.

 When you hold the button on the controller down,

the skateboard will tilt back into a wheelie and move
forward until the button is released. The skateboard
will then continue to spin until the button is pressed
down again.

Changes or modifications not expressively approved by the manufacturer responsible for compliance could void the user's authority to operate the 

equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Mattel Inc.

333 Continental Blvd.

El Segundo,CA

(310) 252-2400

Screwdriver 
not included

Power OFF

Power ON

R/C toy operates from up to 30 feet (9m) away.

This product operates at a frequnecy of 27MHz