E F Johnson Company 2425795 사용자 설명서

5-34 

Viking™ VP600 Portable Radio Operating Manual

If the message is to be routed via PCTextMessage, a message will be received that 
acknowledges that the message has been forwarded.

If “R to R” is enabled (paragraph Section 5.15.1, "Data Setup for Text Messaging"), an 
acknowledgement message is not received. Instead, the display will show “Msg Sent”.

When a text message is received, a short alternating tone is sounded and the display 
flashes “Text Msg”.

To view the message, press the assigned text message function button. The sender’s Unit 
ID (or alias, if programmed) will be displayed for approximately one second. Following 
this, the text of the message is shown.

If the message is 12 characters or less in length, the text will remain stationary on the 
display.

If the message is longer than 12 characters, the text will scroll across the display.

• To pause scrolling, press the 

 (Menu) button.

• If desired, adjust the message position using the left/right buttons.

• To resume scrolling, press the 

 (Menu) button again.

To send a reply to a received text message:

1 While viewing the received message, press the 

 (Menu) button. The unit enters the 

text message sending mode of paragraph Section 5.15.2, "Sending a Text Message".

2 Send the text of the reply according to the instructions of paragraph Section 5.15.2,