E F Johnson Company 2425795 사용자 설명서
5-34
Viking™ VP600 Portable Radio Operating Manual
Conventional Mode Features
If the message is to be routed via PCTextMessage, a message will be received that
acknowledges that the message has been forwarded.
acknowledges that the message has been forwarded.
If “R to R” is enabled (paragraph Section 5.15.1, "Data Setup for Text Messaging"), an
acknowledgement message is not received. Instead, the display will show “Msg Sent”.
acknowledgement message is not received. Instead, the display will show “Msg Sent”.
5.15.3 Receiving a Text Message
When a text message is received, a short alternating tone is sounded and the display
flashes “Text Msg”.
flashes “Text Msg”.
To view the message, press the assigned text message function button. The sender’s Unit
ID (or alias, if programmed) will be displayed for approximately one second. Following
this, the text of the message is shown.
ID (or alias, if programmed) will be displayed for approximately one second. Following
this, the text of the message is shown.
If the message is 12 characters or less in length, the text will remain stationary on the
display.
display.
If the message is longer than 12 characters, the text will scroll across the display.
• To pause scrolling, press the
(Menu) button.
• If desired, adjust the message position using the left/right buttons.
• To resume scrolling, press the
(Menu) button again.
Note
The message displayed is the message most recently received. To view messages received
earlier, refer to paragraph Section 5.15.4, "Viewing Previously Received Messages".
earlier, refer to paragraph Section 5.15.4, "Viewing Previously Received Messages".
5.15.3.1
Replying to a Received Text Message
To send a reply to a received text message:
1 While viewing the received message, press the
(Menu) button. The unit enters the
text message sending mode of paragraph Section 5.15.2, "Sending a Text Message".
2 Send the text of the reply according to the instructions of paragraph Section 5.15.2,