Xiamen Puxing Electronics Science & Technology Co. Ltd. PXDZ558V002 사용자 설명서

 
 
 
 
 
 
   

   12. OPERATIONS   AND  SETTINGS

 

 

This function can decrease power consumption when no signal is received. and no operation is
perfo- rmed. 
You can use programming software to open or close this function.

 

It's prompting signal transmit finshed. You can use programming software to open or close this
function.

 

It can elimianate the end roger beep. For wearing headphone users, tail elimination is very
clearly. You can use programming software to set this function.

 

Low battery warning alerts you that the battery should be recharged or replaced. While
transmitting or receiving, the LED will blink red if the battery is low. it will remind "Low
Voltage" at interval 30 seconds, if turn off the voice function, sound "DU DU DU" prompt.

 

 
 

13. OPERATIONS   AND  SETTINGS 

Step: 
1. Use cable to connect Master unit to slave unit, and turn on the slave unit. Press and hold
program- mable Side Key 2 to turn ON master unit, LED flash Orange twice into clone statue. 
2. Press PTT of Master unit to transmit the data and Slave unit begin to receive data from Master
unit 
3. During cable cloning Master unit blink red and Slave unit blink Green

 

4. When cloning completed, slave unit restart automatically.

 

5. Switch to next slave unit and power on, press side key 2 of master unit to clone.

 

6. Power off master unit to exit.

 

◆

During data transmission, if no data received 3 seconds Master unit flash Red (0.5s ON, 0.5S

OFF)

 

 

1. Press PTT to send.    2. Release PTT to end.     3. Both.       4. OFF

 

◆

OFF: Press PTT or release it will not send ANI code. 

◆

PRE-ONLY: Press PTT to send the ANI.

 

◆

POST-ONLY: Release PTT to send the ANI.

 

◆

BOTH: Both press and release PTT to send ANI.

 

 

1. NONE               2. MONITOR         3. SCAN ON/OFF         4. HIGH/LOW POWER 
5. TALK AROUND      6. REVERSE          7. PRIORITY SCAN       8. VOX ON/OFF