Brother Industries Ltd. T77H505 사용자 설명서

   

                     

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) This device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that 

may cause undesired operation. 

This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the 

interference by one of the following measures: 

- Reorient or relocate the receiving antenna. 

- Increase the separation between the equipment and receiver. 

- Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 

- Consult the dealer or an experienced radio/TV technician for help. 

FCC Caution: Any changes or modifications not expressly approved by the party 

responsible for compliance could void the user's authority to operate this equipment. 

This transmitter must not be co-located or operating in conjunction with any other 

antenna or transmitter. 

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled environment. This equipment should be installed and operated with 

minimum distance 20cm between the radiator & your body. 

1) The antenna must be installed such that 20 cm is maintained between the antenna 

and users, and 

2) The transmitter module may not be co-located with any other transmitter or 

antenna. 

As long as 2 conditions above are met, further transmitter test will not be required. 

However, the OEM integrator is still responsible for testing their end-product for any 

additional compliance requirements required with this module installed