HP RSVLC1103 사용자 설명서
1
HP M220 802.11n Access Point Safety and Regulatory Information
Safety Information
HP M220 802.11n Access Point Safety and Regulatory Information
Safety Information
For LAN connections:
■
If your LAN covers an area served by more than one power distribution system, be
sure their safety grounds are securely interconnected.
sure their safety grounds are securely interconnected.
■
LAN cables may occasionally be subject to hazardous transient voltages (such as
lightning or disturbances in the electrical utilities power grid). Handle exposed metal
components of the network with caution.
lightning or disturbances in the electrical utilities power grid). Handle exposed metal
components of the network with caution.
■
This product and all interconnected equipment must be installed indoors within the
same building, including all associated LAN connections as described by Environment
A of the IEEE 802.3af standard.
same building, including all associated LAN connections as described by Environment
A of the IEEE 802.3af standard.
Documentation reference symbol. If the product is marked with this
symbol, refer to the product documentation to get more
information about the product.
symbol, refer to the product documentation to get more
information about the product.
WARNING
A WARNING in the manual denotes a hazard that can cause injury
or death.
or death.
CAUTION
A CAUTION in the manual denotes a hazard that can damage the
equipment or create a non-compliant condition.
equipment or create a non-compliant condition.
Do not proceed beyond a WARNING or CAUTION notice until you
have understood the hazardous conditions and have taken
appropriate steps.
have understood the hazardous conditions and have taken
appropriate steps.
Warning: For Indoor Use Only
The access point, AC power adapter, and all connected cables are not designed for
outdoor use.
The access point, AC power adapter, and all connected cables are not designed for
outdoor use.
Warning: Exposure to Radio Frequency Radiation
Although the radiated output power of this device is below the FCC radio exposure
limits, the device should be used in such a manner that the potential for human contact
with the antennas during normal operation is minimized. To avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to the antennas
should not be less than 20 cm (8 inches) during normal operation.
Although the radiated output power of this device is below the FCC radio exposure
limits, the device should be used in such a manner that the potential for human contact
with the antennas during normal operation is minimized. To avoid the possibility of
exceeding the FCC radio frequency exposure limits, human proximity to the antennas
should not be less than 20 cm (8 inches) during normal operation.
!
!
!