Audiovox Corporation ACA300T 사용자 설명서

                             

4 

a. 

Wiring the receiver to the vehicle. Choose a source that only 
has power when the vehicle is running. Connect as shown

 

Using the tap connectors supplied.  
i.  Place the unstripped ignition source wire on the run channel  

ii.  Place the unstripped red power wire completely 

iii.  Fold the tap connector back over the wires and make the 

connection by crimping the u-contact down flush with the 
plastic insulator. 

iv.  Close the top hinged cover until latched.   

b.  Black wire- Chassis/Ground. Using ground ring supplied, 

i.  Place stripped wire (1/4”) inside connector 

ii.  Crimp the connector using a crimping tool to secure the 

wire. 

 

1.  Operating voltage: 11.5V-14.5V 

2.  Operating current: 

                                  Transmitter: 70mA 

                                   Receiver: 180mA 

3.  Operating frequency: 2.4GHz 

4.  Operating temperature: 0℃-50℃ 

 

 

 

 

                             

5

The Monitor is not on after the 
vehicle is started and vehicle is 
in reverse? 

Check the monitor and the receiver 
wiring and connection. 

 

No video signal appears while 
reversing the vehicle? 

Check the rearview Camera and the 
Transmitter wiring connection.   

 

Video image is not sharp 
enough? 

Clean the lens of the camera. 

 

 

1. This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, and 

(2) This device must accept any interference received, including interference 

that may cause undesired operation. 

2. Changes or modifications not expressly approved by the party responsible 

for compliance could void the user’s authority to operate the equipment.