Mitsubishi Electric Corp HS-U577 사용자 설명서
9
CONVERTER BOX CONTROL
VCR Rear Panel
IR Emitter
Cable Box or Satellite Receiver
Connections to IR Emitter
Your VCR will be able to send remote control
channel changing commands to your compat-
ible cable box or satellite receiver. The VCR
uses the IR Emitter to send these commands in
the same way as when you use the hand held
remote that came with the cable box or receiver.
channel changing commands to your compat-
ible cable box or satellite receiver. The VCR
uses the IR Emitter to send these commands in
the same way as when you use the hand held
remote that came with the cable box or receiver.
1
Connect the supplied IR Emitter to
CONVERTER BOX CONTROL on back of
the VCR.
CONVERTER BOX CONTROL on back of
the VCR.
2
Run the wire under or along side the cable
box or satellite receiver and place the end in
front of the cable box and/or satellite
receiver.
box or satellite receiver and place the end in
front of the cable box and/or satellite
receiver.
Hooking Up Your VCR
3
Use the double stick tape to secure the end
of the emitter in the proper place.
of the emitter in the proper place.
IMPORTANT
If you connect both a cable box and
satellite receiver, place the IR Emitter to
face the remote control window
(sensor) in the front of both. If you
cannot place it this way, you can
purchase a dual IR Emitter from your
Mitsubishi dealer.
satellite receiver, place the IR Emitter to
face the remote control window
(sensor) in the front of both. If you
cannot place it this way, you can
purchase a dual IR Emitter from your
Mitsubishi dealer.