DISPLAY & TECHNOLOGY LIMITED 24G-WR1001NS 사용자 설명서

WR1001NS

 

6

and the WPS LED will flash two minutes. 

RESET: The Reset Button has two functions, WPS and Factory Default. With the router 

powered on, When selecting the WPS function,use a pin to press and hold the button 

about 2 seconds, the WPS LED will flash two minutes. The other one, use a pin to press 

and hold the button about 6 seconds, the router will restore to factory default. 

POWER: The Power socket is where you will connect the power adapter. Please use the 

power adapter provided with this router. 

Wireless antenna: To receive and transmit the wireless data. 

Before installing the router, make sure your PC is connected to the Internet through the 

broadband service successfully. If there is any problem, please contact your ISP. After 

that, please install the router according to the following steps. Don’t forget to pull out the 

power plug and keep your hands dry. 

1. Make sure all devices, including your PCs, modem, and router, are powered down.

2. Using an Ethernet network cable, connect the LAN or Ethernet network port of the

cable or DSL modem to the router’s WAN port.

3. Power on the cable or DSL modem, and power on the PC you wish to use to configure

the router.

4. Connect the included power adapter to the router. And connect the other end of the

adapter to an electrical outlet.