CRE Electronic Technology Company Limited X3001 사용자 설명서
05
04
Insert
USB
flash
driver
T F
card
/
Insert the storage device into the corresponding port, then the USB flash driver/TF card
will be connected to the projector..
Connect
the
Video
Connect the video equipment to the projector by video cable.
Connect
the
Audio
Insert earphone or 3.5mm audio cable to the projector audio output ,insert the audio cable
from DVD , Set Top Box or other signal devices to the audio input .Then there will be audio
out to the earphone or external mini speaker.
Turn on/
off
the
Projector
1.Connect one end of the power cord to the
wall power supply socket (A), and the other
end connected to the three hole socket (B)
of the projector.
wall power supply socket (A), and the other
end connected to the three hole socket (B)
of the projector.
Adjust
Image
Using image focusing control button (Located
on the side of the projector)
Adjust the projected image sharpness(A).
Using image zoom control button (Located on
the side of the projector)
Adjust the projected image size (B).
Set
the
Remote
Control
The remote control is equipped with a 3V lithium battery
(CR2032). Battery was pre-installed in the remote control.
(CR2032). Battery was pre-installed in the remote control.
If shipping way does not support battery, you need to buy it.
Before using the remote control, take out the plastic
sheet from the battery compartment.
Change
Remote
Control
battery
1.Toward the direction of arrow ,move and pull out of the cover.
2.Remove the old battery, install new battery(the positive upward).
3.Fit on battery’s cover.
Note：
1. Can only use 3V lithium battery (Cr2032
2. In accordance with the relevant local regulations dispose the waste batteries.
3. The battery should be taken out if you do not use the equipment for long time.
2. In accordance with the relevant local regulations dispose the waste batteries.
3. The battery should be taken out if you do not use the equipment for long time.
)
The remote control controls the projector through the infrared transmission . Remote
controlling the radius of about 7 m (23 ft) and above or below projector’s range of 15
degrees ,it can work normally (but the remote control can not be perpendicular to the
bottom of the projector ).
If the projector does not response to the remote control instruction, please move it near
to the projector.
product specification
product specification
2.Press remote control button or press button
“ POWER” to turn on /off the projector
“ POWER” to turn on /off the projector