Bosch Security Systems BV NDE8000 사용자 설명서

en | Hardware Installation

FLEXIDOME IP starlight 8000i

2018.11 | 01 |

Installation Manual

Bosch Security Systems

Do not attempt to move the camera lens manually. Do not remove the bubble.

The lens system is motorized for easy commissioning. Moving these parts manually will break

the gears and damage the camera. In order to move or focus the camera lens, always use the

commissioning apps mentioned in this manual.

The hardware installation of the camera summarizes in six main steps:

1.

Prepare the camera

2.

Install the surface mounting plate

3.

Prepare the on-site wiring

4.

Install the camera's base

5.

Connect all wiring

6.

Plug-in and fix the camera top to the base

On delivery, camera top and camera base are fixed together. In order to proceed with the

installation, base and top need to be separated.

–

Camera unpacked

–

TR20 bit mounted to screwing device

1.

Place the camera on a horizontal surface, with the flat bottom of the base facing to the

ground.

2.

Use the provided TR20 security bit to unfasten the four screws, visible in their mounting

holes on the camera top. Do not use any 'similar' looking torque bit.

3.

Note: do not unfasten the screws from the camera top. A second screw thread in the

camera top prevents the screws from falling down when doing an overhead installation.

4.

Lift the camera top off the base.

5.

Set the camera top aside for now.

Local storage on memory cards should only be used for alarm recording. To minimize the risk

of losing information, use multiple, redundant recording systems and a procedure to back up

all digital information.

Up to two local memory cards (SD) can be installed in the camera top.

–

The camera top, detached from the base

–

One or two SD memory cards

1.

Carefully turn around the camera top. The bubble faces down.

2.

Locate the SD slot on the backside of the camera top.