Sanitag Technologies Corporation AC001LAN 사용자 설명서
Setting Up Devices & RF Netwowk
1-18
THIS DOCUMENT IS THE PROPERTY OF SANITAG COMPANY. IT MAY NOT BE COPIED AND REPRODUCED WITHOUT WRITTEN PERMISSION OF SANITAG
COMPANY. COPYRIGHT NOTICES MAY NOT BE REMOVED
5. Then the second reader joined into the network with the device Id is equal to 303.
Thus service manager shows this device information on the screen as shown in
Figure 12 with a red circle. Note that the type of joined devices to the Rf network
are reader devices. Therefore RNID values are examined upto now.
Figure 12 with a red circle. Note that the type of joined devices to the Rf network
are reader devices. Therefore RNID values are examined upto now.
Figure 12- Service manager screen -2
* Second reader is connected with device Id:303.
6. Now, the AT-001-H type of end device will be joined to the Rf network which is
shown in Figure 7. The device Id of the mobile device is 50884 as in Figure 7.B.
When this mobile device enters the Rf network, MID information has to be read in
order to see whether the mobile is connected to the network or not. In Figure 13,
this phenomena is illustrated. In this figure, mobile device had been joined to the
network with the MID:50884.Remark that the MID is the abbreviation of mobile
device identity.
When this mobile device enters the Rf network, MID information has to be read in
order to see whether the mobile is connected to the network or not. In Figure 13,
this phenomena is illustrated. In this figure, mobile device had been joined to the
network with the MID:50884.Remark that the MID is the abbreviation of mobile
device identity.
Figure 13 - Service manager screen -3
* AT-001-H type mobile device is connected with device Id: 50884.