3B TECH Inc COOL-P800 사용자 설명서
14
RolliBot RolliCool Mini-Split AC User Manual
Ensure that the rubber stopper is placed in a suitable location. If the Indoor and Outdoor Units are disconnected e.g. when
the unit is being moved, the rubber stopper should be reinstalled into the end of the Coupler. If separating the two, review
the following section.
the unit is being moved, the rubber stopper should be reinstalled into the end of the Coupler. If separating the two, review
the following section.
3.3 – Connecting the Coupler
Step 1.
Unscrew the screw at the right side of the
cover. Push the button at the right side of the
cover and pull it away from the unit to remove
it.
cover. Push the button at the right side of the
cover and pull it away from the unit to remove
it.
Step 2.
Remove the rubber stopper from the end of
the Coupler if it is installed. Open the latch
and line the Coupler up with its connectors.
the Coupler if it is installed. Open the latch
and line the Coupler up with its connectors.
Step3.
Make sure the Coupler is properly threaded
into its connectors and push it straight down.
into its connectors and push it straight down.
Step 4.
Slowly close the latch, taking care to use even
pressure on the latch.
pressure on the latch.
Step 5.
Connect the power cable to the inside of the
unit.
unit.
Step 6.
Replace the Coupler Cover. Make sure to add
the screw.
the screw.
Cover
Power Cable
Keep the Coolant
Lines straight
11
RolliBot RolliCool Mini-Split AC User Manual
Section 3. Setting Up the AC
3.1 – Installing the Indoor Unit
• Choose a mounting location situated next to a window as the Coolant Lines must be run through a window in order to
keep the Indoor and Outdoor Units connected.
keep the Indoor and Outdoor Units connected.
• Using a stud detector for detection and installation into wall studs may be desired for more secure mounting.
Step 1.
Choose a suitable
location on the wall for
mounting the unit.
mounting the unit.
Step 4.
Use a drill to make 4 holes at each of the marks.
Step 5.
Insert the Wall Anchors into the wall.
Step 6.
Add the screws into their anchors making sure a length of
4mm~9mm is left out of the wall.
4mm~9mm is left out of the wall.
Step 7.
Install the Indoor Unit onto the wall making sure the
notches in the Mount Openings slide over the screws.
Step 8.
Check to ensure the Indoor Unit is securely installed on the
wall.
wall.
Step 9.
Remove the Indoor Unit for now to prepare for connection.
After installing the Outdoor Unit (Section 3.2) and Connecting
the Coupler (Section 3.3), reinstall the Indoor Unit on the wall.
Step 2.
Measure between the
Mount Openings on the back
of the unit.
of the unit.
Step 3.
Mark locations on
the wall according to the
openings.
openings.
H
L
Rollibot-MiniSplitAC-UM-0403.indd Spread 11 of 12 - Pages(14, 11)
Rollibot-MiniSplitAC-UM-0403.indd Spread 11 of 12 - Pages(14, 11)
4/10/2017 7:41:36 PM
4/10/2017 7:41:36 PM