CM GLOBAL KTX433-UART 사용자 설명서

There is a channel setting switch as shown in the Figure, defined as A1, A2, and A3 
respectively, where A1~A3 is for channel setting. 

1 

0 

0 

0 

432.700Mhz 

2 

1 

0 

0 

433.100Mhz 

3 

0 

1 

0 

433.500Mhz 

4 

1 

1 

0 

433.600Mhz 

5 

0 

0 

1 

434.000Mhz 

6 

1 

0 

1 

434.300Mhz 

7 

0 

1 

1 

434.600Mhz 

8 

1 

1 

1 

434.900Mhz 

FCC Notices 

This device complies with Part 15 of the FCC rules. Operation is subject to the  

following two conditions: 1) this device may not cause harmful interference, and 2)  

this device must accept any interference received, including interference that may  

cause undesired operation. 

Note: This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation. 

This equipment generates uses and can radiate radio frequency energy and, if not  

installed and used in accordance with the instructions, may cause harmful  

interference to radio communications. However, there is no guarantee that  

interference will not occur in particular installation. If this equipment does cause  

harmful interference to radio or television reception, which can be determined by  

turning the equipment off and on, the user is encouraged to try to correct the  

interference by one or more of the following measures: 

--Reorient or relocate the receiving antenna. 

--Increase the separation between the equipment and receiver. 

--Connect the equipment into an outlet on a circuit different from that to which the  

receiver is connected. 

--Consult the dealer or an experienced radio/TV technician for help. 

Changes or modifications not expressly approved by the party responsible for  

compliance could void the user’s authority to operate the equipment. 

 

FCC Radiation Exposure Statement 

This device complies with FCC RF radiation exposure limits set forth for an  

uncontrolled environment. This transmitter must not be co-located or operating in  

conjunction with any other antenna or transmitter.