DLK Electronic Limited M80 사용자 설명서
damage to waterproof case.
How to close the waterproof case
Snap the LATCH-2 on the back cover and press the LATCH-2 down.
NOTES:
In order to capture a clear video or photo, please tear off the lens protection film of the waterproof shell before
use, and protect well the lens window from scratch
use, and protect well the lens window from scratch
after use.
Before sealing the waterproof case, keep the camera housing’s White Silicone Seal Ring clean, a single hair or
grain of sand cause a leak. You can test by closing the case without inserting the camera. Submerse the case
completely in the water for about a minute. Remove the case from the water, dry off its exterior with a towel, and
then open the case. If the interior is dry,the case is safe for use under water.
grain of sand cause a leak. You can test by closing the case without inserting the camera. Submerse the case
completely in the water for about a minute. Remove the case from the water, dry off its exterior with a towel, and
then open the case. If the interior is dry,the case is safe for use under water.
Before sealing the waterproof case
, make sure the waterproof case is sealed well before use.If the white silicone
sealing ring is found to be hardened, deformed or damaged, please stop using this water tank and replace the
new waterproof shell in time
new waterproof shell in time
Please dry it in time after use, otherwise the waterproof shell metal button or other metal parts will dust and
reduce the waterproof performance. After use in in seawater or seaside, you will need to rinse the outside of the
housing and the metal parts with fresh water and then dry. This will prevent corrosion of the hinge pin and salt
buildup in the seal, which can cause failure. Do not flush the interior with water.
reduce the waterproof performance. After use in in seawater or seaside, you will need to rinse the outside of the
housing and the metal parts with fresh water and then dry. This will prevent corrosion of the hinge pin and salt
buildup in the seal, which can cause failure. Do not flush the interior with water.
When use the camera with the waterproof in low temperature, such as Winter, Rainy Day, Underwater and so on,
please do the anti fogging treatment so as to avoid the blurred video. It is recommended to add anti-fog film;
insert the anti-fog film into the waterproof case to prevent the lens from fogging in low temperature or humid
environment;
please do the anti fogging treatment so as to avoid the blurred video. It is recommended to add anti-fog film;
insert the anti-fog film into the waterproof case to prevent the lens from fogging in low temperature or humid
environment;
Keep it safe from falling and dropping and high temperature above 80°C.
Waterproof shell is vulnerable product, we strongly recommend ,according to the usage of the environment and
frequency, to replace the waterproof shell in time.
frequency, to replace the waterproof shell in time.
FCC Statement:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device
may not cause harmful interference, and 2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device
may not cause harmful interference, and 2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.