Lenovo BT500 사용자 설명서
Regulatory notices
USA
—
Federal Communications Commission
(FCC)
—
Lenovo 500 2.0 Bluetooth Speaker
FCC ID
FCC ID: A5MBT500 (Model: BT500)
FCC RF safety requirement
The radiated output power of the Bluetooth device is
far below the FCC radio
frequency exposure limits. Therefore, a 20 cm of
separation between the
Bluetooth antenna and human body is not required.
Radio Frequency interference requirements
The Bluetooth devices have been tested and found
to comply with the limits for
both a Class B digital device regarding FCC Part 15
Subpart B and an intentional
radiator regarding FCC Part 15 Subpart C.
Federal Communications Commission
Models: BT500
This equipment has been tested and found to
comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which
the receiver is connected.
the receiver is connected.
•
Consult an authorized dealer or service
representative for help.
Lenovo is not responsible for any radio or television
interference caused by unauthorized changes or
modifications to this equipment. Unauthorized
changes or modifications could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Responsible Party:
Lenovo (United States) Incorporated
1009 Think Place-Building One
Morrisville, NC 27560
Telephone: 1-919-294-5900
Lenovo is not responsible for any radio or television
interference caused by unauthorized changes or
modifications to this equipment. Unauthorized
changes or modifications could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Responsible Party:
Lenovo (United States) Incorporated
1009 Think Place-Building One
Morrisville, NC 27560
Telephone: 1-919-294-5900
Canada
—
Industry Canada (IC)
IC Certification number
Approved wireless devices
This section presents the IC Certification and model
number of each wireless device.
Preinstalled integrated Bluetooth device
•
IC: 5903G-BT500 (Model: BT500)
Low power license-exempt radio communication
devices (RSS-210)
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
Exposure of humans to RF fields (RSS-102)
The device employ low gain integral antennas that
do not emit RF field in excess of Health Canada
limits for the general population; consult Safety
Code 6, obtainable from Health Canada's Web site
at http://www.hc-sc.gc.ca/.
The radiated energy from the antennas connected to
the bluetooth speaker conforms to the IC limit of the
RF exposure requirement regarding IC RSS-102,
Issue 4 clause 4.2.
Num
é
ro d'homologation IC
P
é
riph
é
riques sans fil homologu
é
s
Cette section pr
é
sente le num
é
ro d'homologation IC
et le num
é
ro de mod
è
le de chaque p
é
riph
é
rique
sans fil.
Émetteur Bluetooth int
Émetteur Bluetooth int
é
gr
é
pr
é
install
é
•
IC: 5903G-BT500 (Model: BT500)
Remarque relative aux appareils de
communication radio de faible puissance sans
licence (CNR-210)
Le fonctionnement de ce type d'appareil est soumis
aux deux conditions suivantes:
1. Cet appareil ne doit pas perturber les
communications radio.
2. Cet appareil doit supporter toute perturbation, y
compris les perturbations qui pourraient provoquer
son dysfonctionnement.
Exposition des
ê
tres humains aux champs radio
é
lectriques (RF) (CNR-102)
L'appareil utilise des antennes int
é
grales
à
faible
gain qui n'
é
mettent pas un champ
é
lectromagn
é
tique sup
é
rieur aux normes impos
é
es par le Minist
é
re de la sant
é
canadien pour la population.
Consultez le Safety Code 6 sur le site Web du
Minist
Minist
é
re de la sant
é
canadien
à
l'adresse
http://www.hc-sc.gc.ca.
L'
L'
é
nergie
é
mise par les antennes reli
é
es aux Haut –
parleur Bluetooth sans fil respecte la limite
d'exposition aux radiofr
d'exposition aux radiofr
é
quences telle que d
é
finie
par Industrie Canada dans la clause 4.2 du
document CNR-102.
document CNR-102.