Yamaha Corporation DKV137138 사용자 설명서

다운로드
페이지 28
Wireless LAN  
 
 
Copyright statement 
 
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form 
or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the 
prior writing of the publisher. 
 
Printed in Taiwan, May. 2002 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
User manual                                                                 Wireless LAN 11 Mbps  
 
2
RADIATION EXPOSURE STATEMENT
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is no 
proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency 
energy (RF) in the microwave range while being used.  Whereas high levels of RF can produce health effects (by heating tissue), exposure to 
low level RF that does not produce heating effects causes no known adverse health effects. Many studies of low level RF exposures have not 
found any biological effects. Some studies have suggested that some biological effects might occur, but such findings have not been confirmed 
by additional research. The 
WD05740
 has been tested and found to comply with the Federal Communications Commission (FCC) guidelines on 
radio frequency energy (RF) exposures. The maximum SAR levels tested for the 
WD05740
 
has been shown to be 
0.563W/kg
 at 
body.
 
This device should not be co-located or operated with any other antenna or transmitter.
In addition, use of the equipment other than PDA may not ensure compliance with FCC RF exposure quidlines.
STATEMENTS REGARDING THE WIRELESS LAN CARD
FCC  AND INDUSTRY CANADA INFORMATION (U.S.A , CANADA)
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to 
operate the equipment.Properly shielded an grounded cables and connectors must be used for connection to host computer and / or peripherals
in order to meet FCC emission limits.
The installer of this radio equipment must ensure that the antenna is located or pointed such that 
it does not emit RF field in excess of Health Canada limits for the general population; consult Safety 
Code 6, obtainable from Health Canada's website 
www.hc-sc.gc.ca/rpb
« L'installateur du présent matériel radio doit s'assurer que l'antenne est située ou pointée
de manière à ce que cette dernière n'émette pas de champs radioélectriques supérieurs aux
limites spécifiées par Santé Canada pour le grand public; 
consulter le Code de sécurité 6,
disponible sur le site Web de Santé Canada, à l'adresse suivante : www.hc-sc.gc.ca/rpb. »
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may 
cause undesired operation.
L'utilisation de ce dispositif est autorisee seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) l'utilisateur du dispositif doit etre pret a accepter
tout brouillage radioelectrique recu, meme si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif. 
FCC INFORMATION (U.S.A)
1.
2.
3.
IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in this manual, meets FCC reqirements. Modifications not expressly
approved by Yamaha may void your authority, granted by the FCC, to use the product.
IMPORTANT: When connecting this product to accessories and/or another product use only high quality shieldedcables. Cable/s supplied
with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use
to use this product in the USA.
NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital 
devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential
enviroment will not result in harmful interference with other electronic devices. This requirement generates/uses radio frequencies and, if not
installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic
devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be
 the source of interference, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problem by using one of
the following measures:
Relocate rither this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead, change the lead-in to 
co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of  product. If
you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe
Ave, Buena Park, CA 90620