Orion Electric Co Ltd M115A 사용자 설명서

23

Note:
• If your mobile phone supports A2DP protocol, its 

music will play through the CD receiver.

• You can build a Bluetooth connection with a mobile 

phone, an iPod or any other Bluetooth-enabled 
devices.

Tip:
• Alternatively, you can use the remote controller’s 

[ /LINE] button.

the top panel. to put the CD receiver into the 
pairing mode.
“Pairing...” appears on the CD receiver’s display.
If you hold the [

Bluetooth PAIRING] button for 

more than 2 seconds during the process of pairing, 
the operation will be cancelled.

During this period, you can operate the 
mobile phone, iPod or Bluetooth-enabled 
device to pair with the CD receiver within a 
10m range.
For details on the Bluetooth connection, refer to the 
user manual of the Bluetooth-enabled device.
The CD receiver may not work as normal 
depending on the circumstance even though the CD 
receiver is placed within the 10 m range. In such 
cases, get the Bluetooth-enabled device closer to 
the CD receiver and retry the operation.

Once the CD receiver is detected and its 
name “Onkyo CR-245BT” appears on the 
display of your Bluetooth-enabled device, 
select the “Onkyo CR-245BT.” If a prompt 
requests a password, key in the “0000”.
When a Bluetooth connection is established 
successfully, the “

” indicator will be solid on 

and “Bluetooth” appears on the display of the CD 
receiver.

1/3” 

button on your device. The CD receiver 
automatically starts playing the audio.
If the “

” indicator is not lit and “Bluetooth” 

appears on the display of the CD receiver after 2 
minutes have elapsed after “Pairing...” appears, this 
means that the pairing is not done successfully. 
Perform the above procedure 1 to 4 again.

Note:
• If there is no sound output even after the paring is done 

successfully, consult the user manual of the Bluetooth-
enabled device, and then select the 
“Onkyo CR-245BT” as the audio output device.

• The CD receiver can store the pairing information of 

up to 8 Bluetooth devices. If the pairing is done for the 
ninth Bluetooth device, the pairing information of 
device connected via Bluetooth in the most past times 
is erased.

• The multiple Bluetooth devices cannot be connected 

at the same time.

If you press the [DISPLAY] button during the Bluetooth 
connection, the following Bluetooth information 
appears.

The information is shown in the following order.

With Bluetooth Standby, you can set the CD receiver so 
that it will be automatically turned on if the Bluetooth 
device is operated while the CD receiver is on standby.

The default setting is “Off”.

Make settings for this function while CD receiver is in 
standby mode.

8 ON/STANDBY] button on 

The SLEEP indicator will be dimly-lit.

Note:
• To switch between “On” and “Off” , repeat this 

procedure.

E39_CS-355_En_120614.book  23 ページ  ２０１２年６月１４日　木曜日　午後１時４８分

TENTATIVE