Hong Fu Jin Precision Electrons Co. Ltd. MRDB20 사용자 설명서
Contactless Smart Card Reader Module
‐ Uart, SPI, and I2C Interface ‐
Model : MIC‐001
Thank you for purchasing our products.
The contactless smart card reader module
is mainly to support the reader and peer2peer function. The
small footprint size of the module and facility interface make it easily to integrate into all the platform. The
module communicates with a host computer or terminal using a standard Uart, SPI, I2C interface.
module communicates with a host computer or terminal using a standard Uart, SPI, I2C interface.
FEATURES
ś
Hardware‐based support for the ISO/IEC 18092, ISO/IEC 21481, ISO/IEC 14443 Type A/B, JIS(X) 6319‐4, and
ISO 15693 standards
ISO 15693 standards
ś
No active component requirement for antenna or field‐power conditioning.
ś
Individual byte framing
ś
Hardware‐based collision detection and modulation controls
ś
256‐byte FIFO for either TX or RX paths, configurable to be 128‐byte for TX and 128‐byte for RX in full‐duplex
mode
mode
ś
Reader/Writer (R/W) mode
ś
Active and Passive Peer (P2P) mode
ś
Internal low‐power oscillator for periodic wake‐up and mode switch operation.
ś
NFC Forum NFC Controller interface (NCI) for host interface.
ś
ARM Cortex‐M0 processor with 128KB ROM and 19KB RAM.
ś
Integral Low‐Drop Out (LDO regulator for direct connection to platform battery.
ś
Clock sourced from platform reference frequency input for minimum BOM (or external XTAL option).
ś
Supports UART, SPI, and I2C host interface.
ś
Multiple low‐power modes for complete flexibility and power management.
ś
Low‐power consumption in all modes and support for field‐power mode.
ś
Minimum hardware size and BOM
SPECIFICATIONS
Page 1 of 4
Communication
Supports Uart, SPI, and I2C host interface.
Power Requirements
2.8 or 3.1 Vdc
Power Consumption
Under 250 mA in operating mode
Operating temperature
0 to 55 centigrade
Operating Humidity
20 to 85% (non dew)
Dimensions
26L x 17.5W mm, without antenna board