Dukane Corporation TURNON01 사용자 설명서

Perform the following steps to train the receiver after it has been wired to the accessory and to a 12 Volt power
source.
1. Remove the two phillips head screws and remove the cover from the receiver housing.
2. Locate the small jumper block shown in Figure 3 below.  Gently pull up on the jumper block that is pressed

onto one of the pins.  Lift it off of the single pin, reposition it over both pins and gently press it down.
It is now in the training mode.

3. Press the keypad button you wish to use several times.  (You will see the light or accessory turn on and off)

and replace the jumper so that it only covers one pin.
4.

Replace the cover on the receiver.  The receiver will

now respond to the button you pressed.
Note: When the jumper covers both pins (training mode)
the receiver will respond to any button you press.  The
receiver only remembers the last button you press as its
assigned button.

The range of the keypad can be affected by

where you put the receiver in the car.  If you are having
trouble activating the receiver with the keypad, move the
receiver to another location.  See the FAQ section of the
2Kool website for more installation information.

2Kool Technologies

St. Charles, IL 60174

www.2kooltech.com

Compliance Statement ( Part 15.19 )
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1.   This device may not cause harmful interference, and
2.   This device must accept any interference received, including interference that may cause undesired operation.
Warning ( Part 15.21 )

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Select the physical location of your application such as neon lights.  Install the
lights in accordance with the manufacturer recommendations.  Connect the

wire from the lights to the receiver wire.  This is the wire on
the right hand side (see figure 2).  The wire with the white
stripe is the ( + ) wire the other wire is the ground wire.
For power connect the wire coming from the left hand side of
the receiver to a 12 Volt source and ground.  The wire with
the white stripe is +12 Volts, the other wire is connected to
ground.
Note:  When mounting receiver unit make sure you have
access to the two phillips head screws on the cover plate.  You
will need to remove the cover to train the receiver.

Figure 2

Figure 3

*Most Underbody Kits
 Exceed 1 Amp