RadioShack Corporation 610140R 사용자 설명서

This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, 
and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more 
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and 

receiver. 

• Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected. 

This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, 
including interference that may cause undesired operation.
Consult your local RadioShack store or an experienced 
radio/TV technician for help. If you cannot eliminate the 
interference, the FCC requires that you stop using your door 
chime. Changes or modifi cations not expressly approved 
by RadioShack may cause interference and void the user’s 
authority to operate the equipment.

This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one 
(1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. 
For complete warranty details and exclusions, check with your local RadioShack store.

RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04

61-2117

AO0185ABA1

06A04

Printed in China

Frequency 

433.92 MHz ± 600KHz

Doorbell current consumption 

<10mA

Chime current consumption 

<2mA @ standby

 

< 130mA @ sound playing

Chime battery low 

2.4V ± 0.1V

Chime audio power 

> 80dBA @ 25cm

Doorbell operating temperature 

–20

o

C to 60

o

C

 

(–4

o

F to 140

o

F)

Specifi cations are typical; individual units might vary. 
Specifi cations are subject to change without notice. 

  Slide your 

chime to ON.

 Press one of your 

two doorbells. Your 
chime will “ding 
dong” for doorbell 
1

 and play “Home 

Sweet Home” for 
doorbell 2

.

You can expand your doorbells to sound an 
additional alarm. To do this, you will need to 
wire one or both doorbells to an alarm that 
contains a normally open contact.

  Connect both tips of a 2-conductor wire (not 

supplied) to a doorbell, as shown, using two 
M3 screws.

 Connect both tips of the other end of the

2-conductor wire to the extra alarm.

Now, when you press your doorbell, both the 
chime and the alarm will sound.

 

In the event you need to change or reset the 
channel or your chime and doorbell, use the 
following instructions. 

  Select the same channel (1, 2, or 3)  in the 

wireless door chime and remote doorbell 1.

  Repeat step 1 for remote doorbell 2.

 

61-140