Panasonic Corporation of North America RPBT10R 사용자 설명서

RQT8993

Talking on your cellphone

Talking on the phone

Receiving incoming calls

You will hear the incoming call tone when someone calls
the number of your cellphone.

- To talk to the other party, Press the MIC button on the

receiver.

- To switch the call to your cellphone, Press and hold the

MIC button on the receiver for 2 seconds after the
call has been connected.

- To refuse the call, Press and hold the MIC button on the receiver for 2 seconds during the call tone.

Hanging up

Press the MIC button on the receiver. The call is now terminated.

Notes:

• If you receive a call while music is playing on the iPod

, the iPod

music will be temporarily suspended,

and you will hear the incoming call tone.

•

When the call is terminated, the iPod

music will resume.

Adjusting the call volume

The call volume can be adjusted by pressing the [+] and [-] buttons.

Notes:

• The call volume cannot be adjusted during call standby.

•

You can select separate settings for the call volume level and music play level.

Winding up an operation session

Disconnect the Bluetooth connection using your cellphone.

Note:

• For further details on disconnecting the Bluetooth connection, refer to the operating

instructions of your cellphone.

Press and hold the MIC button on the receiver for 6 seconds.

The receiver’s power is turned off, and its lamp (red) goes off.

■

Listening to music on your cellphone

Setting the pair

In order to establish the wireless connection between the receiver and Bluetooth cellphone, the receiver and
cellphone pair must first be registered.

Before operating the units, check the following points.

• Has the pairing of the receiver and cellphone you are about to use been registered? (Refer to page 18.)

Press and hold the MIC button on the receiver for 2 seconds.

The receiver’s power is turned on, and its lamp (red) starts blinking slowly.

Establish the “audio” connection by performing the Bluetooth

connection operation on your cellphone.

Perform the audio playback operation using the above cellphone.

When the pair setting is completed, the receiver’s lamp (blue) starts blinking slowly.

•

Perform the operation for transmitting to the Bluetooth device.

•

The receiver starts receiving, and the playback sound can be heard through
the earphones.

Note:

• For further details on the Bluetooth connection, refer to the operating

instructions of your cellphone.

MIC

Audio

RQT8993-P(RP-BT10P)0528.indd 20-21

2007/05/28 16:42:03