Furuno USA Inc 9ZWRTR059A 사용자 설명서
3-3
3.3
How to Enter the Initial Settings
After you set the purpose of the radar, enter the initial settings as follows.
1. On the main menu, press T
or S to select Installation.
2. Press the ENTER key. The Installation menu becomes active and the cursor moves to the
right column.
3. Press T
or S to select an item from the Installation menu.
4. Press the ENTER key to show the setting window.
5. Press T
5. Press T
or S to select an option.
6. Press the ENTER key to validate the setting.
7. Press the MENU key to close the main menu.
7. Press the MENU key to close the main menu.
Basic Settings
Input Source: Select the input source from Master and Slave. The default setting is Master.
Master: A display unit operates as the main radar.
Slave: A display unit operates as a remote display. For the remote display, make sure you
adjust the "Video Init Adjust" and "Timing Adjust" (page 3-5 and 3-6).
adjust the "Video Init Adjust" and "Timing Adjust" (page 3-5 and 3-6).
ARPA QV Select: Set to "On" position to display quantized video on the screen. Set to "Off" po-
sition for normal use.
sition for normal use.
Demo Mode: Set to "On" position to activate the demo mode. Set to "Off" position for normal use.
[ENTER]: Enter [CANCEL/HL OFF]: Back
[MENU]: Exit
[MENU]: Exit
System
GPS
Units
Target
ARPA
AIS
Demo Mode
Input Source
ARPA QV Select
Antenna Height
Heading Adjust
: 15m
: 2
: 2
: 0. 0 °
: Off
: Master
: Off
: Off
MBS Adjust*
Auto Install Setup*
Timing Adjust
Near STC Level
: 0
: 0
: 0.000 NM
Menu
Menu
Installation
Installation
Initial
Factory
Sector Blank **
Installation
Total On Time*
: 000000.5 h
Total TX Time*
: 000000.6 h
* : Displayed when scrolled.
Memory Clear*
** : Set the Sector Blank to "Off" in order to
execute Auto Installation Setup in the
Installation menu.
execute Auto Installation Setup in the
Installation menu.
Video Init Adjust*
: 6
ARPA Adjust SP*
: 2
ARPA Adjust MP*
: 2
ARPA Adjust LP*
: 2
Antenna Rotation
: Rotate
Tests
A/C Auto Adjust