Furuno USA Inc 9ZWRTR115 사용자 설명서
8
2.
WIRING
2.1
Connections
2.1.1
Power Requirement
The DRS4D-NXT requires either 12 VDC or 24 VDC power. Connect the red cable to
the positive terminal of ship’s battery; the blue cable to the negative terminal. The
black cable is a shielding cable for grounding.
the positive terminal of ship’s battery; the blue cable to the negative terminal. The
black cable is a shielding cable for grounding.
2.1.2
Network Cable Connection
Connect
Network
cable to the multi function display device*.
*Hereafter TZTL12F, TZTL15F, TZT9, TZT14 and TZTBB are referred to as “multi
function display device”.
function display device”.
2.2
Check Points After Installation
Before using the product, carry out the following:
• Mechanical checks
• Turning the power on and initial setup
• Turning the power on and initial setup
Mechanical checks
Check below points before switching on the DRS4D-NXT.
• All washers are in place and bolts are fully tightened.
• All connections are secure and
• All connections are secure and
Network
cable is connected to the multi function dis-
play device.
• All connecting cables and wires are secured as instructed in page 4.
Turning the power on and initial setup
Use the information in this manual and the manual for multi function display device to
power the sensor and to proceed with initial setup.
power the sensor and to proceed with initial setup.
1. Ensure that all personnel are clear of antenna.
2. Press and hold down the power key of your multi function display device until the
2. Press and hold down the power key of your multi function display device until the
unit is ON.
3. Take the appropriate action on your multi function display device to turn on the
DRS4D-NXT.
4. Check if the heading is correctly aligned - targets should appear at their correct
bearing relative to the boat’s bow. Adjust the alignment if necessary, referring to
section 2.3.
section 2.3.