Bionime Corporation GM782 사용자 설명서

Performing a Quality Control Test

9. Tightly replace the cap on the

Control Solution GC700 bottle.

10. The control solution result will appear. Compare your Quality Control Test result

to the Control Solution Range printed on the

Blood Glucose Test

Strip GS700 vial label.

Rightest

Performing a Quality Control Test

CAUTION
- Your Control Solution Test results will not be included in the average calculations, however,

they can still can be recalled and viewed. The Control Solution Test result will be shown
with the " " icon on the screen.

- The Control Solution Test should be conducted between 43-111°F (6-44°C).
- Before " " and " " appear, do not touch the control solution to the sample port on the

strip. The

Blood Glucose Meter GM782 is performing an internal check.

Touching the control solution to the sample port before prompted will result in an error
message: " " and " "

- Do not drip the control solution on to the sample port of the test strip directly. The reagent

on the strip might leak into the bottle of control solution and may cause the degeneration

of the control solution. This could contaminate the meter via the test strip port.
- Keep the test strip port clean and dry. Clean immediately if the test strip port is
stained or is overly exposed to moisture.

- Do not touch the tip of the control solution bottle. If the tip is touched, clean
with water.

Rightest

and be accompanied by beeps (if volume is turned on)

1. Take one

Blood Glucose Test Strip GS700 from the vial

and close the vial cap immediately.

2. Insert the strip into the test strip port of the

Blood

Glucose Meter GM782 with the view window facing up.

3. While the blood drop icon is flashing on the display window, press

and hold the Main button for at least 3 seconds until the " "
symbol appears.

4. You will see the blinking " " icon and " " icon on the screen,

prompting you to apply the corresponding level of
Control Solution GC700.

5. Shake the bottle of

Control Solution GC700 well before

opening the cap. Place the cap on a flat surface.

6. Place a drop of control solution onto the top of the cap.
7. Gently touch the sample port of the strip with the control solution from

the top of the cap.

Rightest

The screen will display the count time starting from 5 (you will hear a
beep if the volume is turned on).

OPEN

GM782