ICOM 269800 사용자 설명서

41

7

SCAN OPERATION

■ Skip channel setting

The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.

q Select a memory channel:

➥ Push [M/CALL

] to select memory mode.

➥ Rotate [DIAL] to select the desired channel to be a skip

channel.

w Push [SET

] to enter set mode.

e Push [SET] or [MONI] several times until “CHS” appears

as shown above.

r Rotate [DIAL] to turn the skip function ON or OFF for the

selected channel.

• “~” appears

: The channel is skipped during scan. 

(CHS-ON)

• “~” disappears : The channel is scanned during scan.

(CHS-OFF)

t Push any other key than [SET] or [MONI] to exit set mode.

z Select a memory channel.

➥ Select memory mode by pushing [MR/CALL].

➥ Push [Y

Y] or [Z

Z] to select the desired channel

to be a skip channel.

x Push [

B(D-OFF)] to enter set mode.

c Push [

B(D-OFF)] or [

C(T-OFF)] several

times until “CHS” appears as shown at left.

v Push [Y

Y] or [Z

Z] to set or cancel the skip setting.

• See item r at left for skip indicator details.

b Push [

A(MW)] to exit set mode.

☞ NOTES:

Even though scan edge channels cannot be set as skip
channels, they ARE skipped during memory scan.

SET mode cannot be accessed when memory names are
displayed. To set the scan resume condition, return to fre-
quency indication by pushing [MONI

] on the front

panel for 1 sec., or push [FUNC] then [

1(ANM)] (HM-

133V) to cancel the channel name indication, then set as
described on this page.

SET

B

The display shows that 
memory channel 1 is set 
as a skip channel.