ICOM 279100 사용자 설명서
25
7
CLONING
Cloning allows you to quickly and easily transfer the
programmed data from one transceiver to another
transceiver, or, data from a PC to a transceiver, using the
optional CS-A24 (#02)
programmed data from one transceiver to another
transceiver, or, data from a PC to a transceiver, using the
optional CS-A24 (#02)
cloning
software
.
ï
Transceiver to transceiver cloning
q
Connect the OPC-474
CLONING CABLE
with adapter
plugs to the [SP/MIC] jack of the master and sub trans-
ceivers.
ceivers.
• The master transceiver is used to send data to the sub trans-
ceiver.
w
While holding down [MR•
MW
], push
[PWR] to enter the cloning mode (to
operate the master transceiver
only).
operate the master transceiver
only).
• “CLONE” appears and the transceivers
enter the clone standby condition.
e
Push [MR•
MW
] on the master trans-
ceiver.
• “CL-OUT” appears in the master trans-
ceiver’s display.
• “COURSE DEVIATION NEEDLES”
shows that cloning is taking place
• “CL-IN” appears automatically in the
sub transceiver’s display.
r
When cloning is finished, turn power OFF, then ON again
to exit the cloning mode.
to exit the cloning mode.
NOTE: DO NOT transfer the data from a IC-A24 to a IC-
A6, when the data contains the NAV band data. In such
case, a cloning error may occur.
A6, when the data contains the NAV band data. In such
case, a cloning error may occur.
ï
Cloning using PC
Data can be cloned to and from a PC (Microsoft
®
Windows
®
XP) using the optional CS-A24 (#02)
cloning
software
and
the optional OPC-478 (RS-232C type), OPC-478U or OPC-
478UC (USB type)
478UC (USB type)
cloning
cable
. Consult the CS-A24
(#02)
cloning
software
HELP file for details.
ï
Cloning error
NOTE: DO NOT push [ENT•
WX
] on the sub transceiver
during cloning. This will cause a cloning error.
When the display at right appears, a
cloning error has occurred.
cloning error has occurred.
In this case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
clone standby condition and cloning must be repeated.
Microsoft and Windows are registered trademarks of Micro-
soft Corporation in the U.S.A. and other countries.
soft Corporation in the U.S.A. and other countries.
“COURSE DEVIATION
NEEDLES” shows that
cloning is taking place.
2
3
3
1
4
5
6
7
5
6
7
9
10
10
8
12
13
13
11
14