ICOM 296400 사용자 설명서
46
10
PAGER/CODE SQUELCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
• PERSONAL CALLS
This display appears when you are called with your ID code
and the calling station’s ID code is 123.
and the calling station’s ID code is 123.
• GROUP CALLS
This display appears when you are called with the group
code, 888, and 888 has been programmed into code channel
C6.
code, 888, and 888 has been programmed into code channel
C6.
• ERROR INFORMATION
When the transceiver receives an incomplete code, “E” and
previously received code appear.
previously received code appear.
■
Code squelch
When using code squelch you will only receive calls from sta-
tions which know your ID or group code. A 3-digit code is sent
each time
tions which know your ID or group code. A 3-digit code is sent
each time
[PTT]
is pushed in order to open the receiving sta-
tion’s code squelch prior to voice transmission.
q Set the operating frequency.
• Set the volume and squelch to the desired level as in normal op-
eration.
w Push
[FUNC]
, then push
[
OPT
]
(0).
• Rotate
[VOL]
to select “dtm.CS,” if “dtm.PG” or “dtm.OF” ap-
pears.
e Select the desired transmit code channel:
➥ Push and hold
[
OPT
]
(0) for 1 sec. to enter code selec-
tion mode.
➥ Rotate
[VOL]
(or push
[
Y
Y
]
/
[
Z
Z
]
) to select the desired
code channel.
➥ Push
[
✱
ENT
]
(or
[CLR]
) to exit code selection mode and
return to previous mode.
• 100 MHz digit shows “C.”
r Operate the transceiver in the normal way (push
[PTT]
to
transmit; release
[PTT]
to receive).
t To cancel the code squelch, push
[FUNC]
and
[
OPT
]
(0),
then rotate
[VOL]
to select “dtm.OF.”
• 100 MHz digit shows “1” when the function is cancelled.
Previously received code.
Code channel
“CP” and “ ” blink.
During channel number indication
(described on page 20)
To use these functions in channel number indication, the
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.
pager/code squelch setting must be programmed with other
memory contents before selecting channel number indication.