ICOM 297410 사용자 설명서

4

2

  0

1

  0

2

■

The flow chart below shows the basic operating procedures. 
You  need  to  set  the  frequency,  activate  the  frequency,  and 
receive or transmit. 
There are two ways to set the frequency. Refer to page 5 and 
6 for details.

Set the frequency normally
Set the desired frequency which will be used for the next op-
erating frequency in the standby frequency display. Then ex-
change the active frequency for the standby frequency.

Set the frequency directly
You can directly enter the desired frequency.
Refer to ‘Directly setting the frequency.‘

For quick frequency setting, you can enter often-used 

frequencies into memory channels. Refer to “MEMORY OP-
ERATION” for details. (pp. 7–13)
When you recall a memory channel, the previous standby 
frequency is erased.

  Set the standby frequency.

  Activate the frequency.

  Enter the direct frequency 
  setting mode.

  Set the operating frequency.

Receive/transmit